HotelInfantesAgres - Tempat Tanya Jawab Pelajaran & Ilmu Pengetahuan Logo

Questions in engineering

[Jawaban] The purpose of a reheat coil when dehumidifying is to A. dry the moisture out of the air. B. prevent the air from freezing. C. regenerate the evaporator coil. D. decrease the relative humidity by increasing the air temperature.

[Jawaban] A front-wheel drive vehicle has a broken condenser line. What other vehicle component may also be defective that could have caused the condenser line to break? A) Shock absorbers B) AC compressor drive belt C) Cooling fan D) Engine mounts

[Jawaban] Which of the following is true about using accessories, such as earmuffs, while wearing a hard hat? A. They should only be worn in restricted areas B. They must be installed by a qualified person C. They must not interfere with the fit of the hard hat D. They will decrease the level of protection provided by the hard hat

[Jawaban] Question 2 (5 points) Listen When replacing an air-conditioning component, all of the following regarding refrigerant oil are true except: A) The oil removed during refrigerant recovery should be measured. B) The oil charge stamped on the compressor should be added to the system. C) The old oil should be replaced with fresh oil. D) The old oil should be drained from the component and measured. Question 3 (5 points) Listen Technician A says a defective thermostat will cause the engine to operate at too cold of a temperature. Technician B

[Jawaban] The door used to control interior temperature is called the A. recirculation B. temperature-blend C. outside (fresh) air D. mode door.

[Jawaban] Explain fault finding principles and techniques for alternating and direct current main supply circuits.

[Jawaban] Environmental sustainability and human health considerations play important roles in decisions that engineers make as they create and design products. A. False B. True

[Jawaban] Listen Which of these is least likely a step in replacing a failed compressor? A) Flushing the system B) Replacing the condenser C) Disconnecting and sealing the hoses D) Inspecting the muffler

[Jawaban] Select the best answer for the question. What's needed to calculate the CFM required to provide a given number of air changes in a building? A. Floor area, ceiling height, and fan horsepower B. The floor area, ceiling height, and an enthalpy chart C. The floor area and ceiling height D. A psychrometric chart and an enthalpy chart

[Jawaban] Which statement describes the purpose of tags when locking and tagging out? A. They communicate danger and warn workers not to start, energize, operate, or close that equipment. B. They identify that a piece of equipment will not operate due to repairs or maintenance. C. All of the above